Online Guitar Tuner
Tune six-string guitar in standard EADGBE, drop D or open G. Mic detection tuned to the guitar range plus string reference tones for tuning by ear.
--
Press Start to begin tuning
Works best in a quiet environment. Use headphones if playing back audio to avoid feedback.
Online guitar tuner: standard, drop D and open G by ear or microphone
A guitar in standard tuning has six open notes, from the thickest string to the thinnest: E2, A2, D3, G3, B3 and E4. Drop D changes the first one to D2. Open G changes three of them, giving D2, G2, D3, G3, B3 and D4. Selecting the wrong tuning can make an accurate microphone reading look wrong. Choose the tuning on this page before playing a string. Then use the open-string tones to compare by ear or start the microphone and watch the cents display.
Which notes are in each preset?
Standard EADGBE is the default for most six-string guitar material. Drop D lowers only the sixth string from E2 to D2, a difference of two semitones. Open G uses DGDGBD, also listed low to high. The third, fourth and fifth strings keep their standard notes, while the other three move down a whole step. These exact open-string notes are the targets in the selector, not guesses from the last chord you played. Fender's drop D guide confirms the DADGBE sequence, and its open G guide lists DGDGBD. Recheck a chord shape after changing tuning, because familiar shapes may sound different.
Read the cents indicator
Play one open string at a time in a quiet room. The tuner compares the pitch it detects with the nearest open string in the selected preset. A positive number means the detected pitch is sharp relative to that target; a negative number means it is flat. Zero is the target. The green zone is within 5 cents. For scale, 100 cents is one equal-tempered semitone. If the number is very large, check which string you played and whether your guitar is close to the chosen tuning. The needle stops at the edge of its display; the printed cents number can go beyond that edge.
Where the reference tones come from
The string buttons play short sine tones in string order, using the same browser oscillator module as the tone generator. At A4 = 440 Hz, low E2 is about 82.41 Hz; D2 is about 73.42 Hz. The note is computed from the MIDI note number using the equal-tempered formula: frequency = A4 times 2 raised to (MIDI number minus 69) divided by 12. Your audio output may not reproduce the lowest reference strongly. Headphones or speakers can distort your impression of the bass notes, so use the microphone view if a reference tone seems unusually faint.
Why the microphone ignores some notes
This page listens around the open-string range of your selected tuning, with three semitones of room at either end. A high fret or a voice in the room should not become an open-string target. The tuner still cannot know which string you physically touched. If you pluck a string more than a few semitones away from its intended pitch, it may identify the nearest other open note. Bring it close by ear first. If you want a tuner for fretted notes, violin or other instruments, use the chromatic tuner instead. It does not restrict readings to guitar open strings.
Tuning stability in practice
Pick the note once, then let it ring for a moment before adjusting the peg. The attack can sound sharp; read the steadier part of the note. Tune up toward the target rather than stopping after loosening the string, then check again after a few seconds. A change in sixth-string tension can move the other strings slightly, particularly after switching to drop D or open G. Run through all six strings again when you finish. If a string buzzes after a major tuning change, the string gauge or guitar setup may need attention. The Fender tuning tips cover quiet-room tuning and letting a plucked string settle.
Calibration and other guitar work
A4 defaults to 440 Hz. If your group uses a different concert pitch, move the calibration slider from 415 to 466 Hz before tuning. Changing A4 moves every target together. For example, setting A4 to 442 Hz also raises the calculated E2 reference; it does not create a new alternate string pattern. If you are working from chord charts after switching tuning, check fingerings with the chord chart generator. If a singer needs the song in another pitch, the chord transposition tool addresses the written harmony, not the physical tuning of your guitar.
Limits of a browser tuner
The browser needs microphone permission, a quiet room and a clear sustained note. Autocorrelation estimates a repeating waveform period, so loud harmonics can sometimes appear as an octave error. The display smooths successive readings and attempts to suppress sudden octave jumps, but it cannot guarantee the true fundamental for every guitar or pickup. Reference playback runs locally and stops automatically. Microphone audio stays in the browser; this tool does not record or upload it. If you are setting intonation or diagnosing a damaged pickup, use a dedicated measurement setup rather than a quick web reading.